E-mail: kathy@zozen.com LIVE CHAT
HOME  /  describe bridge control of steam turbines with the associated boilers

describe bridge control of steam turbines with the associated boilers

SZS series gas-fired (oil-fired) steam boiler

SZS series gas-fired (oil-fired) steam boiler

SZS series boiler is designed with longitudinal double drums and " D " type chamber structure. Furnace is placed on the right and convection tube bank is on the left, super heater is arranged at convection tube bank. The body is fixed on the basement by middle and both end flexible supports and make the boiler expand horizontally sideways. Around the furnace is membrane water cooling tube wall. Furnace and tube bank are totally separated by the membrane water tube cooling wall at the left side of the furnace.

Email:kathy@zozen.com

Get a Quote Send Inquiry
DHL series biomass-fired steam boiler

DHL series biomass-fired steam boiler

DHL corner tube boiler is field assembled boiler, it uses a piping system as the frame of the entire boiler, and it bears the full load of the boiler, which makes a non-framework boiler. At the same time, this frame also serves as the down comer of the boiler and upper and lower headers. The boiler drum is an external type drum, the furnace is a fully enclosed membrane wall structure, the convective heat absorbing surface adopts the flag tube structure.

Email:kathy@zozen.com

Get a Quote Send Inquiry
CFB (circulating fluidized bed) coal fired steam boiler

CFB (circulating fluidized bed) coal fired steam boiler

As a new mature high-efficiency and low-pollution clean coal technology, circulating fluidized bed combustion (CFBC) technology has many advantages that other combustion methods do not have. Circulating fluidized bed combustion is low-temperature combustion, so the NOx emission is much lower than that of pulverized coal furnace, only 200ppm. CFBC can desulfurize directly during the combustion process, and the desulfurization efficiency is high.

Email:kathy@zozen.com

Get a Quote Send Inquiry
RYQ series molten salt heater

RYQ series molten salt heater

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal oil heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

Email:kathy@zozen.com

Get a Quote Send Inquiry
  • marine control systems: integrated systems for all …

    Marine Control Systems: Integrated Systems for All …

    This article will give you the clear picture of marine control system used on board the ship and its control station. Mainly some of the few important automatic control systems employed on board the ship are bridge control of main engine, boiler control, turbine control, diesel generator control and turbo generator control from the engine control room.

    Read More
  • bridge control of main steam propulsion …

    BRIDGE CONTROL OF MAIN STEAM PROPULSION …

    Author: H O Walker

    Marine Steam Turbines and Main Boilers_

    Read: 202

    Chapter 14 Boilers - Pearson Education

    2019-2-20 · Boilers 291 Coagulation—a method for concentrating and removing suspended solids in boiler feedwater by adding chemicals to the water, which causes the impurities to cling together, p. 301. Condensate—condensed steam, which often is recycled back to the boiler, p. 294. Damper—a movable plate that regulates the flow of air or flue gases in boilers,

    Read More
  • annex b of cmo no. 20, series of 2015 bachelor of …

    ANNEX B OF CMO NO. 20, SERIES OF 2015 BACHELOR OF …

    2017-10-2 · including control from bridge, machinery control room, engine control local and changeover controls o Describes bridge control of controllable-pitch propellers o Describes bridge control of slow speed diesel engines o Describes bridge control of steam turbines with associated boilers o Describes bridge control for gas turbines with

    Read More
  • steam turbines start-ups - imp.gda.pl

    Steam turbines start-ups - imp.gda.pl

    2017-2-15 · Steam turbines start-ups 171 Prior to switching on the turning gear, oil system is started up. It is always necessary to check whether lube oil pumps has started and whether all bearings are supplied with oil. Control of lube oil pressure and temperature, as well as rotor axial displacement and eccentricity is necessary. The turning gear can be

    Read More
  • steam turbines and boilers - university of rijeka

    Steam Turbines and Boilers - University of Rijeka

    2018-10-17 · Steam Turbines and Boilers has been rung, the nozzle control, manoeuvring, guardian, Bridge to turn the turbines/propeller. Once permission is granted, then the turning gear is to be engaged and the turbines rotated with the lubricating oil supply maintained, low vacuum, and gland steam …

    Read More
  • marine steam turbines operating procedure

    Marine steam turbines operating procedure

    2019-1-30 · Marine steam turbines operating procedure First open all the turbine-casing and main steam-line drain valves and ensure that all the steam control valves at the manoeuvring station and around the turbine are closed. They are used in conjunction with watertube boilers to provide a secondary steam circuit which avoids any possible

    Read More
  • steam turbine - an overview | sciencedirect topics

    Steam Turbine - an overview | ScienceDirect Topics

    Steam Turbines. The two main standards for steam turbines are API 611—General Purpose Steam Turbines, and API 612—Special-Purpose Steam Turbines. When selecting a steam turbine as a driver for an oil and gas application, the user must select either API 611 or API 612 standard to be followed.

    Read More
  • boiler explosion - wikipedia

    Boiler explosion - Wikipedia

    2020-2-21 · A boiler explosion is a catastrophic failure of a boiler.As seen today, [when?] boiler explosions are of two kinds. One kind is a failure of the pressure parts of the steam and water sides. There can be many different causes, such as failure of the safety valve, corrosion of critical parts of the boiler, or low water level. Corrosion along the edges of lap joints was a common cause of early

    Read More